This article mainly introduces:

Estonia hydraulic cylinder,yg series hydraulic cylinder manufacturer,yg series hydraulic cylinder

(Estonia yg series hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

yg series hydraulic cylinder are widely used in Estonia，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed yg series hydraulic cylinder for customers from Estonia.

Introduction to yg series hydraulic cylinder:

At the rated pressure, the thrust of the yg series hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the yg series hydraulic cylinder is related to the diameter of the yg series hydraulic cylinder, but not to the stroke of the yg series hydraulic cylinder. Moreover, the larger the yg series hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the yg series hydraulic cylinder.

Do not regularly check the damage of the chrome layer of the yg series hydraulic cylinder: completely extend the yg series hydraulic cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the yg series hydraulic cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the yg series hydraulic cylinder seal. Welding slag is strictly prohibited on the surface of the yg series hydraulic cylinder.

If the piston rod and yg series hydraulic cylinder are stuck or the yg series hydraulic cylinder is blocked, at this time, no matter how to operate, the yg series hydraulic cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the yg series hydraulic cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

yg series hydraulic cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the yg series hydraulic cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.

Answers to some questions about yg series hydraulic cylinder:

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.

What is the thin cylinder used for?
The principle is no different from ordinary cylinders, that is, the installation space is small, the formation is small, and it is suitable for some special occasions. For example, the space is compact and the place of small travel is used.