This article mainly introduces:

Australia hydraulic cylinder,tension cylinder manufacturer,tension cylinder

(Australia tension cylinder,produced by Hengyu Group）

tension cylinder are widely used in Australia，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed tension cylinder for customers from Australia.

Introduction to tension cylinder:

When the tension cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the tension cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

If the seal of the tension cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

The definition of the minimum stable speed refers to the minimum movement speed of the tension cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the tension cylinder that undertakes different work has different requirements for the minimum stable speed.

Under normal circumstances, the tension cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the tension cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the tension cylinder and the end cover, the piston and the piston rod, the piston and the tension cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the tension cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

Answers to some questions about tension cylinder:

What is the cause of the sound of the excavator arm cylinder?
Hydraulic excavator cylinder includes boom cylinder, bucket rod cylinder and bucket cylinder, four cylinders. The sound of boom cylinder may be the wear of hydraulic cylinder block bushing, piston rod bushing and shaft pin. The main reason: poor lubrication, followed by improper clearance in the assembly process. Countermeasures: (1) Strictly lubricate each shaft pin at least once every 8 hours when the excavator is initially used for 100 hours and under harsh conditions; In other working conditions, lubricate each pin at least once every 50 hours. (2) If the lubricating oil passage is found to be blocked, it must be stopped for rectification. (3) Require assembly, replacement of all parts of the shaft pin, bushing strictly comply with the assembly testing standards and operating procedures.

What are the problems that cause hydraulic cylinder shaking?
1, the oil supply is not smooth, the hydraulic oil filter is half blocked. 2. The oil level in the oil storage tank is lower than the minimum oil level. 3, there is air in the hydraulic system. 4, the supply oil pump is damaged or not working properly. 5, the hydraulic oil is not replaced for a long time.