This article mainly introduces:

Guatemala hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Guatemala unidirectional cylinder,produced by Hengyu Hydraulic Co., Ltd）

unidirectional cylinder are widely used in Guatemala，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed unidirectional cylinder for customers from Guatemala.

Introduction to unidirectional cylinder:

The method of sleeve unidirectional cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the unidirectional cylinder can be significantly improved by rolling in the finishing of the inner holes of the unidirectional cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.

Do not enter foreign bodies when installing the unidirectional cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

The unidirectional cylinder should be vented: when the unidirectional cylinder is installed or parked for a long time to work again, the air will penetrate into the unidirectional cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the unidirectional cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the unidirectional cylinder, the oil is best entered and discharged from the highest point of the unidirectional cylinder. unidirectional cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

unidirectional cylinder can not drive the load troubleshooting: oil pressure is too low. unidirectional cylinder selection specifications are too small. Leakage in unidirectional cylinder or associated hydraulic system element.

Answers to some questions about unidirectional cylinder:

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.

Injection molding machine die thimble on the side of the feed nozzle, the oil cylinder pull the thimble shift, how to debug the oil cylinder?
The cylinder is connected with the neutron of the injection molding machine, the neutron is retreated after the opening mold is in place, the cylinder taps the thimble plate to the top, and then takes, and the neutron is reset.