This article mainly introduces:

Malaysia hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Malaysia steering cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steering cylinder are widely used in Malaysia，because of clever hydraulic energy conversion，clever hydraulic energy conversion，high work efficiency.So our company has designed steering cylinder for customers from Malaysia.

Introduction to steering cylinder:

If it is found that the steering cylinder lubrication is poor or the steering cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the steering cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the steering cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the steering cylinder center line. In this way, when the piston works in the steering cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the steering cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

The steering cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure steering cylinder can use 20 steel pipe, and the high pressure steering cylinder can use 45 steel pipe.

In order to ensure the service life of the steering cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the steering cylinder, causing damage to the seal and causing leakage in the steering cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

When the steering cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the steering cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

Answers to some questions about steering cylinder:

What is the cylinder with rod cavity, what is the rodless cavity.
The rod cavity is the end of the piston rod, the rodless cavity is the end without the piston rod.

How to calculate the tonnage of hydraulic cylinder? The tonnage of the cylinder refers to the output force of the cylinder under rated working pressure: 1, for single rod piston hydraulic cylinder, it can be calculated by the area of the circle corresponding to the inner diameter of the cylinder A (square centimeter), and the rated working pressure of the system p (mpa), the value is equal to 10pA kg force, and the ton is 0.01pA. 2, for the double rod piston hydraulic cylinder, with A(square centimeter) to indicate the cylinder cylinder diameter and piston rod outer diameter defined by the ring area, with p (mpa) to indicate the rated working pressure of the system, the output force of the cylinder is 0.01pA ton force.