This article mainly introduces:

Uganda hydraulic cylinder,pushing cylinder manufacturer,pushing cylinder

(Uganda pushing cylinder,produced by Hebei Hengyu company）

pushing cylinder are widely used in Uganda，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed pushing cylinder for customers from Uganda.

Introduction to pushing cylinder:

There are some honeycomb holes in the inner wall of the pushing cylinder, piston or piston rod surface. How is this formed? When we repair the pushing cylinder, we can see that there are some honeycomb holes on the inner wall of the pushing cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the pushing cylinder is targeted to prevent. Is very necessary.

When the pushing cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

pushing cylinder installation precautions: Before installing the pushing cylinder into the system, the parameters on the pushing cylinder label should be compared with the parameters when ordering. The base of the pushing cylinder must have sufficient stiffness, otherwise the pushing cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

The pushing cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

Answers to some questions about pushing cylinder:

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.

The hydraulic cylinder is slow when moving forward and faster when moving back.
If the cylinder is single, it is slow when it is moving forward without the rod cavity, and fast when it is shrinking.