This article mainly introduces:

Burma hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Burma trailer hydraulic cylinder,produced by Hebei Hengyu company）

trailer hydraulic cylinder are widely used in Burma，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed trailer hydraulic cylinder for customers from Burma.

Introduction to trailer hydraulic cylinder:

If it is found that the trailer hydraulic cylinder lubrication is poor or the trailer hydraulic cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the trailer hydraulic cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the trailer hydraulic cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the trailer hydraulic cylinder center line. In this way, when the piston works in the trailer hydraulic cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the trailer hydraulic cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

The trailer hydraulic cylinder is not the same as the trailer hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the trailer hydraulic cylinder can not be used as a high-power power component, but the trailer hydraulic cylinder can be used as a relatively large power component, or the trailer hydraulic cylinder system can be used.

When the trailer hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the trailer hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The body of the trailer hydraulic cylinder on the processing process requirements: the body of the trailer hydraulic cylinder is an important and essential part of the trailer hydraulic cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the trailer hydraulic cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

Answers to some questions about trailer hydraulic cylinder:

What are the reasons why the hydraulic cylinder action is slower than normal?
There are many factors that cause this problem. First, measure the pressure of the main system to see whether the pressure of the main system under the pressure state is consistent with the initial setting. Before measuring the pressure, it is best to check the hydraulic oil and suction oil filter and replace or clean it. Second, check the main relief valve of the reversing control multiway valve to see if there is damage or foreign matter blocking, and clean it. If your pump is a gear pump, the problem should generally be small. Second, look at traffic. There is no leakage in the cylinder, leakage in the reversing valve spool and so on.

What is the role of the cylinder on the plastic mold? The oil cylinder plays a great role in the mold, one is that the core distance is very large, or because of the mechanism of the product, only the oil cylinder is reasonable or more cost saving. Let the side core be extracted before opening the mold. Hot runner is mainly based on the product, sometimes customers require to use hot runner, the price is more expensive, but there are many benefits. It can save raw materials and shorten the molding cycle.