This article mainly introduces:

Malaysia hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Malaysia tailplate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

tailplate hydraulic cylinder are widely used in Malaysia，because of no need for deceleration device，long service life，smooth movement.So our company has designed tailplate hydraulic cylinder for customers from Malaysia.

Introduction to tailplate hydraulic cylinder:

If the tailplate hydraulic cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

How to repair the tailplate hydraulic cylinder body when it is damaged: When the tailplate hydraulic cylinder has trace deformation and shallow tensile marks, the tailplate hydraulic cylinder is repaired by strong honing process. The heavy honing process can repair tailplate hydraulic cylinders up to 2.5 times out of tolerance than the original tolerance. It honed the parts with excessive size or shape error through a powerful honing machine, so that the overall size, shape tolerance and roughness of the tailplate hydraulic cylinder can meet the technical requirements.

tailplate hydraulic cylinder installation precautions: Before installing the tailplate hydraulic cylinder into the system, the parameters on the tailplate hydraulic cylinder label should be compared with the parameters when ordering. The base of the tailplate hydraulic cylinder must have sufficient stiffness, otherwise the tailplate hydraulic cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

After chrome plating of the piston rod of the tailplate hydraulic cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

Answers to some questions about tailplate hydraulic cylinder:

How many kilograms can the 63 cylinder hold?
The force of the cylinder is related to the cylinder diameter and pressure. 63 cylinder diameter (cylinder inner circle diameter), 21MPA pressure, thrust 6 tons.

How to change the seal ring of lift oil cylinder of forklift truck?
Remove the cylinder, put it on the vise, first screw off the big nut plug on the head, and then pull out the guide sleeve, you can directly pull out the core of the cylinder, if it is to change the seal of the cylinder head, the core does not need to be pulled out, if it is to change the seal inside, pull it out and see the oil seal, remove it and replace it, there are three seals of the cylinder head, the inner seal, The outer seal, dustproof, it is best to replace them all together, and be sure to keep them clean when changing, and you can lubricate them with clean hydraulic oil.