This article mainly introduces:

Canada hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Canada steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

steering cylinder are widely used in Canada，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed steering cylinder for customers from Canada.

Introduction to steering cylinder:

In recent years, the processing process of the steering cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.

In the process of using the steering cylinder, sometimes such a problem will occur, the steering cylinder can not act immediately after the instruction of the steering cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil steering cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Piston steering cylinder is widely used in hydraulic transmission. When the steering cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the steering cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the steering cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

Causes and countermeasures of oil steering cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the steering cylinder will lead to premature wear of the piston seal, replace the piston seal; If the steering cylinder is visibly scarred, the steering cylinder must be replaced. It can be pressurized at one end of the steering cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most steering cylinder piston drift may not come from the steering cylinder, the above method to determine the steering cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

Answers to some questions about steering cylinder:

What's a minus 40 cylinder made of?
Construction with 1Cr18Ni9Ti, in low temperature conditions impact and tensile strength are very good, can withstand -100 degrees of low temperature, corrosion resistance, material price is not very high, more economic.

What are the connection methods of the hydraulic cylinder? The connection modes of the cylinder and the actuator are earring connection, hinge shaft connection, thread connection, etc. The connection modes of tubing and cylinder are threaded connection, flange connection, etc.