This article mainly introduces:

Korea hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Korea vehicle hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

vehicle hydraulic cylinder are widely used in Korea，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed vehicle hydraulic cylinder for customers from Korea.

Introduction to vehicle hydraulic cylinder:

In use, the vehicle hydraulic cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the vehicle hydraulic cylinder.

The vehicle hydraulic cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure vehicle hydraulic cylinder can use 20 steel pipe, and the high pressure vehicle hydraulic cylinder can use 45 steel pipe.

vehicle hydraulic cylinder body inspection: The inner surface of the vehicle hydraulic cylinder and the piston seal are the main factors causing the leakage in the vehicle hydraulic cylinder, if the vehicle hydraulic cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the vehicle hydraulic cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

The difference between the plunger vehicle hydraulic cylinder and the piston vehicle hydraulic cylinder is that the piston in the vehicle hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type vehicle hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Answers to some questions about vehicle hydraulic cylinder:

What is the meaning of cylinder ejection on the injection mold, and what is the difference between cylinder ejection and ordinary ejection?
Usually requires the front die ejection will use the cylinder to drive the thimble plate to achieve the ejection of the thimble. There is also a case that the mold is very large or long, and the balance of the ejector rod of the injection molding machine is not enough, and the cylinder ejector will also be used.

How to take out the diaphragm of hydraulic cylinder? The septum ring is also known as the septum sleeve, when the cylinder is too long, and does not need too much travel, add the septum sleeve, limit the stroke of the hydraulic cylinder, set on the piston rod, only contact with the guide sleeve and piston, do not cooperate with the cylinder, limit the stroke, take out the difficulty is different, need to have such a professional tool, before taking out to consult the manufacturer.