This article mainly introduces:

Azerbaijan hydraulic cylinder,roller press hydraulic cylinder manufacturer,roller press hydraulic cylinder

(Azerbaijan roller press hydraulic cylinder,produced by Hebei Hengyu company）

roller press hydraulic cylinder are widely used in Azerbaijan，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed roller press hydraulic cylinder for customers from Azerbaijan.

Introduction to roller press hydraulic cylinder:

The scar on the sliding surface of the roller press hydraulic cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the roller press hydraulic cylinder wall. Therefore, before installation, these scars must be fully repaired.

Do not enter foreign bodies when installing the roller press hydraulic cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

When the roller press hydraulic cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the roller press hydraulic cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The difference between the plunger roller press hydraulic cylinder and the piston roller press hydraulic cylinder is that the piston in the roller press hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type roller press hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Answers to some questions about roller press hydraulic cylinder:

What is the function of the Reza mounted master cylinder?
The role of the Resa-mounted master cylinder is to pump the concrete from the hopper to the delivery pipe and to provide sufficient concrete outlet pressure so that the concrete can reach the specified location.

How to deal with oil cylinder leakage?
The causes of oil leakage and treatment methods are as follows: (1) The spool is stuck or the valve hole is blocked. When the spool of the flow valve or direction valve is stuck or the valve hole is blocked, the hydraulic cylinder is prone to misoperation or operation failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check valve body for wear. (2) The piston rod and cylinder are stuck or the hydraulic cylinder is blocked. At this time, no matter how to operate, the hydraulic cylinder does not move or moves very little. At this time, it should be checked whether the piston and piston rod seal is too tight, whether it enters the dirt and colloid precipitate: whether the shaft line of the piston rod and the cylinder is in alignment, and whether the wearing parts and seals are invalid.