This article mainly introduces:

Thailand hydraulic cylinder,hydraulic jig cylinder manufacturer,hydraulic jig cylinder

(Thailand hydraulic jig cylinder,produced by Hebei Hengyu company）

hydraulic jig cylinder are widely used in Thailand，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed hydraulic jig cylinder for customers from Thailand.

Introduction to hydraulic jig cylinder:

In order to ensure the service life of the hydraulic jig cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

The hydraulic jig cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the hydraulic jig cylinder, bite. Elimination method: When installing the hydraulic jig cylinder, ensure that the axis position of the hydraulic jig cylinder is consistent with the direction of movement; Make the load borne by the hydraulic jig cylinder as far as possible through the hydraulic jig cylinder axis, to avoid the phenomenon of eccentricity.

When the hydraulic jig cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the hydraulic jig cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil hydraulic jig cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical hydraulic jig cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the hydraulic jig cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

When the oil pressure of the hydraulic jig cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

Answers to some questions about hydraulic jig cylinder:

The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.