This article mainly introduces:

Jordan hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Jordan vehicle hydraulic cylinder,produced by Hebei Hengyu company）

vehicle hydraulic cylinder are widely used in Jordan，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed vehicle hydraulic cylinder for customers from Jordan.

Introduction to vehicle hydraulic cylinder:

When the vehicle hydraulic cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

The body of the vehicle hydraulic cylinder on the processing process requirements: the body of the vehicle hydraulic cylinder is an important and essential part of the vehicle hydraulic cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the vehicle hydraulic cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

Regular maintenance of the vehicle hydraulic cylinder includes: regular tightening, vehicle hydraulic cylinder fastening screws and gland screws, vehicle hydraulic cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the vehicle hydraulic cylinder once a year. Clean regularly, the vehicle hydraulic cylinder is cleaned every other year, and the seals are replaced while cleaning.

If the vehicle hydraulic cylinder slips or crawls, please check whether there is astringency inside the vehicle hydraulic cylinder, because the internal parts of the vehicle hydraulic cylinder are improperly assembled, the parts are deformed, worn or the shape and position tolerance is excessive, the action resistance is too large, so that the piston speed of the vehicle hydraulic cylinder changes with the different stroke position, and the slip or crawl occurs. Most of the reasons are due to poor assembly quality of parts, surface scars or sintered iron filings, so that the resistance increases, the speed decreases. For example, the piston is different from the piston rod or the piston rod is bent, the vehicle hydraulic cylinder or the piston rod is offset from the mounting position of the guide rail, and the sealing ring is too tight or too loose. The solution is to repair or adjust, replace damaged parts and remove iron filings.

Answers to some questions about vehicle hydraulic cylinder:

How to distinguish cylinder rod head and cylinder bottom?
One end of the piston rod can be telescopic is the rod head, and the one behind is the bottom of the cylinder, which is the single rod cylinder.

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.