This article mainly introduces:

Spain hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Spain servo hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

servo hydraulic cylinder are widely used in Spain，because of no need for deceleration device，long service life，smooth movement.So our company has designed servo hydraulic cylinder for customers from Spain.

Introduction to servo hydraulic cylinder:

servo hydraulic cylinder use should try to avoid sealing belt into the servo hydraulic cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the servo hydraulic cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the servo hydraulic cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

When the servo hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the servo hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

When the long-stroke servo hydraulic cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in servo hydraulic cylinder head seal damage, oil leakage, and piston sleep in the servo hydraulic cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the servo hydraulic cylinder; The piston and the piston rod are connected with a spherical joint.

Regular maintenance of the servo hydraulic cylinder includes: regular tightening, servo hydraulic cylinder fastening screws and gland screws, servo hydraulic cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the servo hydraulic cylinder once a year. Clean regularly, the servo hydraulic cylinder is cleaned every other year, and the seals are replaced while cleaning.

Answers to some questions about servo hydraulic cylinder:

What is the role of the cylinder on the plastic mold? The oil cylinder plays a great role in the mold, one is that the core distance is very large, or because of the mechanism of the product, only the oil cylinder is reasonable or more cost saving. Let the side core be extracted before opening the mold. Hot runner is mainly based on the product, sometimes customers require to use hot runner, the price is more expensive, but there are many benefits. It can save raw materials and shorten the molding cycle.

What is the thin cylinder used for?
The principle is no different from ordinary cylinders, that is, the installation space is small, the formation is small, and it is suitable for some special occasions. For example, the space is compact and the place of small travel is used.