This article mainly introduces:

Uruguay hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Uruguay shearing machine cylinder,produced by Hengyu Group）

shearing machine cylinder are widely used in Uruguay，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent fatigue and impact resistance.So our company has designed shearing machine cylinder for customers from Uruguay.

Introduction to shearing machine cylinder:

The daily inspection of the shearing machine cylinder includes: checking the connection of the shearing machine cylinder and the pipe joint for leaks. Check the shearing machine cylinder rod for leaks. Check the shearing machine cylinder connection for leaks. When the shearing machine cylinder moves, the work is normal and smooth. Whether the shearing machine cylinder has internal leakage.

Before the shearing machine cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

When the hydraulic oil is not pumped into the shearing machine cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the shearing machine cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

shearing machine cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the shearing machine cylinder head itself is the guide sleeve of the piston rod, the shearing machine cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the shearing machine cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

Answers to some questions about shearing machine cylinder:

What is hydraulic cylinder？ How to use hydraulic cylinder？ what is the application of hydraulic cylinder?
Hydraulic cylinder is the hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating movement (or swing movement). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides. The hydraulic cylinder is basically composed of cylinder body, cylinder head, piston, piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential. Hydraulic cylinders are mainly used in machinery.

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.