This article mainly introduces:

Argentina hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Argentina steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Argentina，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed steel mill cylinder for customers from Argentina.

Introduction to steel mill cylinder:

Factors that should be considered when selecting the oil seal in the steel mill cylinder: some specific factors should be taken into account when selecting the oil seal in the steel mill cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: steel mill cylinder diameter, piston rod diameter, piston rod and piston groove size, steel mill cylinder working pressure, steel mill cylinder movement speed, hydraulic system oil temperature and steel mill cylinder working environment.

When the steel mill cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

When the steel mill cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the steel mill cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

The difference between the integral steel mill cylinder and the split steel mill cylinder: The integral steel mill cylinder and the split steel mill cylinder in the steel mill cylinder are two different steel mill cylinders, and they are very different. The whole steel mill cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split steel mill cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and steel mill cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

Answers to some questions about steel mill cylinder:

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.