This article mainly introduces:

Guatemala hydraulic cylinder,retractable cylinder manufacturer,retractable cylinder

(Guatemala retractable cylinder,produced by Hengyu Group）

retractable cylinder are widely used in Guatemala，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed retractable cylinder for customers from Guatemala.

Introduction to retractable cylinder:

When installing the retractable cylinder, the axial ends of the retractable cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the retractable cylinder, there is axial expansion. If the two ends of the retractable cylinder are fixed, all parts of the retractable cylinder will be deformed. When disassembling the retractable cylinder, it is strictly forbidden to hammer the retractable cylinder and the piston surface, such as the retractable cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

The coordination of the sliding parts of the retractable cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

The retractable cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

When the retractable cylinder thrust is insufficient, check the hydraulic circuit for leaks. Including leakage of valves and hydraulic lines. The inspection method is to check and eliminate the leakage of the hydraulic connection line by manipulating the reversing valve. Also consider the relief valve. If the relief valve enters the dirt and jams the spool, so that the relief valve is normally open, the hydraulic oil will flow directly back to the tank through the relief valve bypass, resulting in no oil in the retractable cylinder. If the load is too large, although the regulating pressure of the relief valve has reached the maximum rating, the retractable cylinder still cannot get the thrust required for continuous action without action. If the regulating pressure is low, the pressure is insufficient to achieve the required vertebra force, which is manifested as insufficient thrust. Check and adjust the relief valve at this time.

Answers to some questions about retractable cylinder:

What is the rated pressure of the general cylinder?
This depends on the model of the cylinder, 1. The rated pressure of the light tie rod cylinder is 7 series 7MPa and 14 series 14MPa. 2. Rated pressure of engineering cylinder 16MPa. 3. Rexroth type metallurgical cylinder rated pressure 250MPa.

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.