This article mainly introduces:

Costa Rica hydraulic cylinder,push plate cylinder manufacturer,push plate cylinder

(Costa Rica push plate cylinder,produced by Hengyu Hydraulic Cylinder Factory）

push plate cylinder are widely used in Costa Rica，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed push plate cylinder for customers from Costa Rica.

Introduction to push plate cylinder:

The advantages and disadvantages of the push plate cylinder: the surface of the push plate cylinder by painting, coating protection treatment, bright luster is not easy to rust, all raw materials of the push plate cylinder through the top heat treatment, high manufacturing precision, belongs to the precision machinery, has a simple structure, stable quality, high mechanical efficiency, easy to achieve automation and many other advantages. However, hydraulic technology also has the shortcomings of oil leakage, oil temperature change affecting the control of running speed, noise, expensive cost and high maintenance cost.

At the rated pressure, the thrust of the push plate cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the push plate cylinder is related to the diameter of the push plate cylinder, but not to the stroke of the push plate cylinder. Moreover, the larger the push plate cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the push plate cylinder.

The scar on the sliding surface of the push plate cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the push plate cylinder wall. Therefore, before installation, these scars must be fully repaired.

The "O" ring can be used as an auxiliary seal inside the push plate cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the push plate cylinder, and can be completely sealed.

Answers to some questions about push plate cylinder:

What is the meaning of dead volume in hydraulic cylinder?
Closed volume, also known as dead zone volume Positive displacement pump is dependent on the change of sealing working volume to achieve suction and pressure oil, in order not to make the suction and pressure oil cavity interworking, there is an oil sealing area between the suction and pressure oil cavity, when the sealing working volume passes through the oil sealing area, neither pressure oil cavity nor oil suction cavity communication, forming a closed sealing volume. The unloading groove is opened, and the grooving principle is that the sealing volume decreases and the oil pressure chamber is communicated, and the sealing volume increases and the oil suction chamber is communicated.

Why does the hydraulic cylinder go up to the top and then slowly go down?
Leakage in the cylinder or the hydraulic valve that controls the cylinder, can be replaced and removed. Or add a pressure retaining valve to the hydraulic system to ensure pressure.