This article mainly introduces:

Congo hydraulic cylinder,synchronous hydraulic cylinder manufacturer,synchronous hydraulic cylinder

(Congo synchronous hydraulic cylinder,produced by Hebei Hengyu company）

synchronous hydraulic cylinder are widely used in Congo，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed synchronous hydraulic cylinder for customers from Congo.

Introduction to synchronous hydraulic cylinder:

The repair method of the synchronous hydraulic cylinder: the repair of the synchronous hydraulic cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

The synchronous hydraulic cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating motion (or swinging motion). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the synchronous hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides; The synchronous hydraulic cylinder is basically composed of synchronous hydraulic cylinder and synchronous hydraulic cylinder head, piston and piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential.

The synchronous hydraulic cylinder is not the same as the synchronous hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the synchronous hydraulic cylinder can not be used as a high-power power component, but the synchronous hydraulic cylinder can be used as a relatively large power component, or the synchronous hydraulic cylinder system can be used.

If the synchronous hydraulic cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Answers to some questions about synchronous hydraulic cylinder:

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.

What is the bearing capacity of the HOB cylinder?
The normal specification of HOB is 140 kg pressure, which is more commonly used in the market, and there are clear marks on the cylinder, 210 kg is a strengthened version of HOB, generally customized cylinders are also clearly marked on the above, when the specific use of the cylinder, the maximum use pressure is marked on the cylinder.