This article mainly introduces:

Thailand hydraulic cylinder,stern plate hydraulic cylinder manufacturer,stern plate hydraulic cylinder

(Thailand stern plate hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

stern plate hydraulic cylinder are widely used in Thailand，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed stern plate hydraulic cylinder for customers from Thailand.

Introduction to stern plate hydraulic cylinder:

If it is found that the stern plate hydraulic cylinder lubrication is poor or the stern plate hydraulic cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the stern plate hydraulic cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the stern plate hydraulic cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the stern plate hydraulic cylinder center line. In this way, when the piston works in the stern plate hydraulic cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the stern plate hydraulic cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

stern plate hydraulic cylinder installation precautions: Before installing the stern plate hydraulic cylinder into the system, the parameters on the stern plate hydraulic cylinder label should be compared with the parameters when ordering. The base of the stern plate hydraulic cylinder must have sufficient stiffness, otherwise the stern plate hydraulic cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

The wear of the hard chromium plating layer of the stern plate hydraulic cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

The stern plate hydraulic cylinder should be used correctly and maintained regularly. The stern plate hydraulic cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the stern plate hydraulic cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

Answers to some questions about stern plate hydraulic cylinder:

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).

For a cylinder with a piston diameter of 100mm and a system pressure of 10MPa, what is the thrust?
Thrust is 7850 kg. Piston area A= πR^2=7850 square mm =78.5 square cm 10MPa = 100kg/cm^2 "^2" is square F = A x P =78.5 x 100=7850 kg.