This article mainly introduces:

Slovenia hydraulic cylinder,trunnion cylinder manufacturer,trunnion cylinder

(Slovenia trunnion cylinder,produced by Hengyu Hydraulic Co., Ltd）

trunnion cylinder are widely used in Slovenia，because of long service life，smooth movement，high work efficiency.So our company has designed trunnion cylinder for customers from Slovenia.

Introduction to trunnion cylinder:

When the trunnion cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

When the trunnion cylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the trunnion cylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

trunnion cylinder can not drive the load troubleshooting: oil pressure is too low. trunnion cylinder selection specifications are too small. Leakage in trunnion cylinder or associated hydraulic system element.

The trunnion cylinder should be used correctly and maintained regularly. The trunnion cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the trunnion cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

Answers to some questions about trunnion cylinder:

How to calculate multistage cylinder volume?
When the multi-stage cylinder is extended, the largest cylinder is extended first, and when the largest cylinder stroke is completed, the second largest cylinder is extended again, the second largest cylinder stroke is completed, the third largest cylinder is extended again... Therefore, the cylinder extension length is less than the stroke of the largest cylinder, and the volume is the extension length times the inner hole area of the largest cylinder. The cylinder extension length is greater than the maximum cylinder stroke and less than (the largest cylinder stroke + the second largest cylinder stroke), and the volume is the largest cylinder stroke times the internal hole area of the largest cylinder + (the extension length - the largest cylinder stroke) times the second largest cylinder.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.