This article mainly introduces:

Egypt hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Egypt vehicle hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

vehicle hydraulic cylinder are widely used in Egypt，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed vehicle hydraulic cylinder for customers from Egypt.

Introduction to vehicle hydraulic cylinder:

Do not enter foreign bodies when installing the vehicle hydraulic cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

When the vehicle hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the vehicle hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The vehicle hydraulic cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

The difference between the integral vehicle hydraulic cylinder and the split vehicle hydraulic cylinder: The integral vehicle hydraulic cylinder and the split vehicle hydraulic cylinder in the vehicle hydraulic cylinder are two different vehicle hydraulic cylinders, and they are very different. The whole vehicle hydraulic cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split vehicle hydraulic cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and vehicle hydraulic cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

Answers to some questions about vehicle hydraulic cylinder:

How to make 4 cylinders balance lifting weight at the same time?
The cost of the synchronous valve is lower, 4 cylinders need 3 synchronous valves, to be precise you can use a synchronous motor, but it is more expensive. There is another way, that is to install a throttle valve in each cylinder, respectively adjust the speed of the cylinder.

How to deal with the surface degreasing process before spraying paint after cylinder assembly, and what degreasing agent is used?
Cylinder painting, generally using the following process (note: the cylinder is best painted, do not spray powder coating, because the powder coating curing temperature is high, will lead to sealing defects and oil leakage) : Pre-degreasing - degreasing - washing - washing - pickling - washing - washing - table adjustment - phosphating - washing - washing - drying - polishing - spray primer - spray paint degreasing agent generally use neutral or weak alkaline degreasing agent, phosphating liquid generally use zinc phosphating liquid.